PolyRenewal Slab Solution

Wednesday, June 6th, 2018 by Samantha Schultz


Over time, concrete is exposed to moisture, temperature changes and chemicals that cause it to look aged and unattractive. But that's just the problem you can see! Once damage from these elements starts, the concrete degrades at an even faster rate. This is not only unsightly — it can also become a safety hazard, lead to pricey concrete repairs and reduce your home's value.

In just one clear, non-yellowing application, PolyRenewal permanently protects your concrete from its strongest enemies: moisture, chemical elements, and seasonal changes. It penetrates deeply into pores and actually bonds with the concrete, creating a strong, permanent barrier. Unlike other concrete sealers, PolyRenewal's Seal of Protection does not wash away or weaken over time. That means your concrete is protected from pitting, flaking and cracking. With PolyRenewal, concrete stays smooth and stain-resistant.

PolyRenewal is installed in four easy steps:

  1. Deep clean surfaces to open concrete pores.
  2. Spray PolyRenewal on concrete surfaces.
  3. Work sealant into surfaces to ensure deep penetration.
  4. Allow to cure for 4 to 6 hours, then use the treated area as usual.

Rest assured that PolyRenewal from Rod Martin's Complete Basement Systems will permanently protect your concrete from damage caused by water, chemicals, and seasonal changes.

 

Jesse washes the concrete to prepare for cleaning. Jesse uses a power scrubber to open the concrete pores for maximum coverage Danish applies the PolyRenewal  barrier for a lifetime of protection!